How To Make Polywood Porch Swing
Polywood porch swing – Instead of buying expensive porch swing that may not be of good quality, build one for much less than buy one in a store, and with much better quality. Building a porch swing is not difficult when using the right tools. When you build your own porch swing, you can design what suits your exact needs and tastes without compromising on anything. Set up two sawhorses on a flat surface to use when cutting your work. Determine the deep and back seat height that you want to swing and then measure it the length of 2-times-4 studs and mark with a pen. Cut six supports 2-times-4 to the right length by hand-laying sawhorses boards and cut the marks with a circular saw. This will give you three supports for the back of the gun and three for the seat.
Cut contours to support if you wish to give the curves in the seat and maybe rounding your back support puzzle piece. The contour lines are completely up to you. Polywood porch swing design is not important as long as all parts are the same. Sand every support smooth with a sanding machine. Attach a seat support and a back support together with two carriage bolts, four washers and two nuts on each section by drilling holes large enough to accommodate transport bolts with a drill and drill bit. Determine the length of your swing. Action 1-of-4 planks with the tape measure and mark the length you need the slats on the planks with a pencil. Place the planks on sawhorses and cut them to size using a circular saw. The total number of planks you need depends on the depth of the seat and the backrest height.
Attach a plank on the front of the seat supports the use of the drill, a little screwdriver and a wooden screw in each support. Repeat the process on the top of the backrest. Load enough planks on the seat part of the frame to finish that section. Space the planks evenly before connecting them with screws. Do not mess a board against another. If you do, the weather causes the board to warp and buckle when expanding and contracting.
Install a screw to connect the plank to each support part using a little drill and screw. Continue until the chair is ready. Place the best polywood porch swing on the back and repeat the procedure with the backrest planks. Determine the size of your arms resting. These should be about 2 inches longer than the total size of seat depth so that they extend beyond the seat 1 inch. Action 1-of-6 with the tape measure and mark your pencil cuts.